Dow FROTH-PAK MINI Instrucciones De Operación página 2

UK
FROTH-PAK™ MINI – OPERATING INSTRUCTIONS
3. Insert the Anti-Crossover Noz-
zle firmly into the front of the
INSTA-FLO™ dispenser. Be sure
the dispenser clips the nozzle
firmly in place.
4. Before dispensing, invert the
unit and grip the can carrier as
illustrated or use the attached
shoulder strap by wearing
across upper torso.
USING THE KIT
Replace nozzle if not used for more than 30 seconds. Nozzle is
removed by depressing the yellow ejector located on the top of the
INSTA-FLO™ dispenser.
1. Hold the INSTA-FLO™ dispenser about 10 cm - 40 cm away from
the area you intend to spray. Note yellow safety on the trigger
must be depressed first, unlocking trigger. Move the INSTA-FLO
dispenser with a steady back and forth motion when dispensing
foam.
2. Foam will expand and will be tack free within 60 seconds, and is
fully cured in five minutes. It is recommended that foam be ap-
plied in layers of 5 cm or less in any single application layer.
Note: If the foam is to be injected into a hidden cavity, a test
shot is recommended prior to each injection.
2
®™ Trademark of The Dow Chemical Company
INSTA-FLO™ DISPENSER
Nozzle
Safety
Trigger
Nozzle Ejector
(see below)
Press down
to eject nozzle
Handle
Hoses