Care And Maintenance - Work Sharp WS2000 Guia Del Usuario

16
Top Side Freehand
Sharpening Tips (top tool
rest use optional)
• Use the coarse abrasive surface for ag-
gressive grinding, or use the fine grit
abrasive surface for light grinding.
• Always place the blade face onto the
right side of grinding wheel so that the
wheel spins away from you.
• Raise tool or handle to create or re-
sharpen a beveled edge if desired.
• The top tool rest can be used to assist in
the sharpening process if desired.
Pull slowly
towards you
• Axes and hatchets are best sharpened
using the top tool rest and a sweeping
motion to grind the bevel. With the
power switch in the "off" position, lay
6

Care and Maintenance

After sharpening only a few tools, sharp-
ening debris will accumulate on your
workbench and also under the grinding
wheel. Sharpening debris may promote
premature wear in the WS2000 unit and
can potentially pose a fire risk. Cleaning
the unit on a consistent basis can add
life to your machine and increase safety.
Before any maintenance or cleaning is
performed, be sure to unplug your WORK
SHARP™ WS2000.
www.worksharptools.com
the bevel onto the wheel and find the
proper grind angle. Then turn on your
machine and grind the corresponding
bevel onto each side of the axe or
hatchet.
• The height adjustability of the top tool
rest can assist in more precise bevel
grinding of your tools. Adjust the top
tool rest and blade projection to achieve
more precise bevel grinding of tools.
Top tool rest height
adjusts up or down
Cleaning your WORK
SHARP™ WS2000
With the WORK SHARP™ WS2000 un-
plugged, remove the grinding wheel to
expose the top of the unit and sharpening
port. Brush away the accumulated sharp-
ening debris from the wheel and sharpen-
ing port area. Remove sharpening debris
with a small, dry brush. Dispose of the
sharpening debris in a safe and environ-
mentally approved manner.