Echo 99944200418 Instrucciones De Instalación

blade conversion kit P/N 99944200418
blade conversion kit P/N 99944200422
Models: ALL SRM Models
WARNING
You must install a Barrier Bar or U-Handle Kit and all Blade Conversion parts shown in the following instruc-
tions before operating this unit with blades, otherwise serious injury may result.
IMPORTANT
If non-standard monofilament heads, METAL/PLASTIC blades or cultivators etc., are used, THE CARBURETOR
MUST BE RESET or serious engine damage can occur. See "Carburetor Adjustment" in the unit Operator's Manual.
TO USE
THESE BLADES
Loop Handle, w/or
Handle
You
must
Debris Shield
install
Harness Shoulder Harness
these
parts!
Blade
Mounting
Hardware
New Cotter Pin***
* WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS
** Arbor diameter of Upper Blade Plate must match arbor diameter of metal blades.
*** New cotter pin required each time blade is installed.
**** Brushcutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness
kit contents
1. Barrier Bar - 4 hole
2. Barrier Bar - 2 hole
3. Screw 5x35 mm (6)
4. Screw 5x10mm (3)
5. Metal Shield
6. Shield Bracket
7. Spring Washer 5mm (4)
8. Nut 5mm (8)
9. Screw 5x8mm (2)
10. Nut 10, left hand
X7672230402
SRM/PAS/SB BLADE SET-UP GUIDE*
Pro Maxi-Cut Rigid Plastic
Grass/Weed Tri-Cut
Plastic Cutters Grass/Weed Blade
Loop Handle
w/Barrier Bar,
w/o Barrier Bar
or U-Handle
Metal Shield Metal Shield
Shoulder Harness
Upper Plate & Upper Plate
Flat Washer & Glide Cup
Hex Nut Hex Nut
New Cotter Pin***
11. Split Pin 2x22 (10)
12. Adapter Plate, lower
13. Adapter Plate upper 20mm (short neck)
14. Collar
15. Adapter Plate upper 20mm (long neck)
16. Harness Ring Assembly
17. Bolt 5x12mm
18. Shoulder Harness w/Quick-release Hook
19. Blade (Kit P/N 99944200422 Only)
20. Torx T27 L-Wrench
b c
lade onversion
i i
nstallation nstructions
Metal
Tri-Cut/8 Tooth
Grass/Weed Blade
Loop Handle
w/Barrier Bar,
or U-Handle
Metal Shield
Shoulder Harness
Upper/Lower
Blade Plates**
Hex Nut
New Cotter Pin***
k
it
Metal 80T Brush Blade
Metal 22T Clearing Saw Blade
U-Handle
Metal Shield
Shoulder Harness****
Upper/Lower
Blade Plates**
Hex Nut
New Cotter Pin***
X767000192
05/09