Echo 99944200200 Instrucciones De Instalación

c :
ontentS
1 - Harness ring
1 - Harness clamp
1 - 5 x 18 mm Bolt
Install Harness Clamp
Tools Required: Screwdriver, 8 x 10mm Open End Wrench.
Parts Required: Shoulder Harness Kit
1. Remove shield and gear housing as an assembly.
a. Loosen two (2) bolts (A) that clamp the gear housing to the
drive shaft.
b. Remove locating screw (B) found at the top of the gear
housing.
c. Pull shield and gear housing assembly (C) from the drive
shaft assembly.
IMPORTANT
Prevent flexible drive cable from sliding from drive shaft housing.
If cable does slide free, clean dirt from cable and re-lubricate with
lithium based grease prior to re-assembly.
2. Remove front handle.
a. Remove screws, and handle bracket (D) from handle.
b. Remove front handle (E).
3. Install clamp.
a. Slightly spread clamp (F) and slide up shaft.
b. Install harness ring (G) using spacer (H) and 5x18mm bolt.
DO NOT tighten at this time.
Install Handle
1. Position handle (E) for comfortable operation, and tighten screws
securely.
SUP22200648
1 - Spacer
1 - Shoulder Harness
S h
houlder arneSS
i i
nStallation nStructionS
P/N 99944200200
G
F
K
it
A
B
C
E
D
I
H
99922200648
07/09