Yakima FrontLoader Manual Del Usuario

Type of
Rack
Load
Round
1 or 2
Bar
bikes
Square
Bar
3 or more
Factory
bikes
Bar
DO NOT EXCEED RACK WEIGHT LIMITS!
If you have factory crossbars, be sure you have
at least 1-1/2" (3.8 cm) of clearance between
the bottom of the crossbar and the vehicle roof.
IMPORTANT WARNING
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR
TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS
PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND
UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU
DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER.
1033564B-1/18
Min. and
Max.
Crossbar
Limits
Spread*
16" - 42" 16" (41 cm) spread =
41cm - 107 cm 30 lbs. (13.6kg)/bike
18" - 42" 18" (46 cm) spread =
46 cm - 107 cm 40 lbs. (18.1kg)/bike
FRONTLOADER (1X)
*CROSSBAR SPREAD
Your crossbar
spread is
the distance
between the
crossbars.
Part #1033564 Rev.B