GE SmartWater GX1S01C Instrucciones De Instalación

Water Filtration System model GX1S01C (Filters not included)
I Check with your local public works department for
plumbing codes. You must follow these guidelines
as you install the Water Filtration system.
I Use the Water Filtration system on a potable, safe-to-drink,
home COLD water supply only. The filter cartridge will not
purify the water, or make it safe to drink.
I Do not use on a hot water supply (100°F. max.).
I Install or store where it will not be exposed to temperatures
below freezing or exposed to any type of weather. Water
freezing in the system will damage it.
I Your Water Filtration system will withstand up to
125 pounds per square inch (psi) water pressure.
If your house water supply pressure is higher than 100 psi,
install a pressure reducing valve before installing the
Water Filtration system.
REQUIRED TOOLS FOR INSTALLATION
I Slotted and Phillips screwdrivers
I Pliers and adjustable jaw wrench
GX1S01C is Tested and Certified
by NSF International against
NSF/ANSI Standards 42 and 53
for the reduction of the claims
specified on the Performance
Data Sheet.
Replacement Filter (not included)
FXUTC – Taste and Odor
FXULC (rev. 2) – Lead and Cyst
Inlet-outlet–3/8" NPT
GE SmartWater
INSTALLATION INSTRUCTIONS
SAFETY PRECAUTIONS
SPECIFICATION GUIDELINES
Service
flow rate
1.0 gpm
0.6 gpm
7239197 215C1044P032
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
™
WARNING:
Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems
certified for cyst reduction may be used on disinfected
water that may contain filterable cysts.
Discard all unused and packaging material after
installation. Small parts remaining after installation
could be a choke hazard.
OPTIONAL KITS AND TOOLS FOR INSTALLATION
NOTE: Installation kit (SSKIT), sump wrench (UCWRNCH)
and faucet (UNFCTBL or UNFCTWW) are sold separately
for model GX1S01C.
I Hand- or battery-powered drill and
valve installation)
I Electric drill and drill bit to drill
required) if mounting hole is needed for faucet
I Pipe cutter
I File
CAUTION:
To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures.
Special drill bits may be needed for porcelain or
stainless steel.
Capacity
3000 gal. or 6 months
600 gal. or 6 months
49-50191
(01-06 JR)
1
" bit (saddle
1 ⁄
4
" hole (type as
3 ⁄
4
Pressure Temperature
40–125 psi 40–100°F
40–125 psi 40–100°F