Eaton Metalux WaveStream Instrucciones De Instalación

ADF140666
Installation Instructions – Luminaire WaveStream
Instructions d'installation - Luminaire WaveStream
Instrucciones de instalación de la luminaria WaveStream
IMPORTANT: Read carefully before installing fixture.
Retain for future reference.
WARNING
Risk of fire, electrical shock, cuts and or other casualty
hazards. This product must be installed in accordance
with the applicable installation code by a qualified
electrician or a person familiar with the construction
and operation of the product and the hazards involved.
Cooper Lighting assumes no responsibility for claims
brought about by improper or careless installation or
handling of this product.
ATTENTION
Receiving Department: Note actual fixture description
of any shortage or noticeable damage on delivery
receipt. File claim for common carrier (LTL) directly
with carrier. Claims for concealed damage must be
filed within 15 days of delivery. All damaged material,
complete with original packing must be retained.
CAUTION
Edges May Cut. Handle with care.
INSTALLATION
Fixture Installation/Wiring
1. Remove product from packaging material. Carton
should be lying down flat, oriented with THIS SIDE UP
markings facing up so that top panel of carton can be
folded back and fixture can be lifted straight up out of
packaging materials. Do not lift fixture by one end or
pull on the end plates in any way. Luminaire should be
handled by both aluminum side rails. Wear clean work
gloves to prevent dirt and oil from being transferred to
luminaire.
2. Note that the protective plastic insert that is shipped
in the luminaire is intended to stay in the luminaire for
protection of the lenses during installation (Figure1.).
Take caution when handling the luminaire to not
scratch or damage the lenses inthe fixture.
CAUTION
Risk of burn. Disconnect power and allow fixture to cool
before changing bulb or handling fixture.
WARNING
Risk of Fire and Electric Shock. If not qualified, consult
an electrician.
NOTICE
Green ground screw provided in proper location. Do not
relocate.
NOTICE
If supply wires are located within 3 inches of ballast, use
wire rated for at least 90°C (194°F).
Figure 1.
Brand Logo
reversed out of
black
INS # INS #
Plastic Insert