Honeywell RedLINK THM6000R1002 Instrucciones Para La Instalación
Honeywell RedLINK THM6000R1002 Instrucciones Para La Instalación

Honeywell RedLINK THM6000R1002 Instrucciones Para La Instalación

Puerta de acceso a internet
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

THM6000R1002 RedLINK™ Internet Gateway
The RedLINK Internet Gateway provides remote access to RedLINK thermostats
through the internet and smart phones.
Must be installed by a trained, experienced technician. Read these instruc-
tions carefully. Failure to follow these instructions can damage the product or
cause a hazardous condition.
Specifications
Model: THM6000R1002
Operating Ambient Temperature: -40 to 165F (-40 to 73.9C)
Operating Relative Humidity: 5% to 95% (non-condensing)
Maximum Number of Hosts: 4 per RedLINK Internet Gateway
A "host" is:
• A thermostat that is wired to the heating/cooling equipment, or to a zone on a
zone panel.
• If the thermostat uses an EIM (Equipment Interface Module), then the EIM is the
host (one thermostat per EIM).
• If the thermostat is linked to an HZ322 or HZ432 zone panel with a THM4000R
wireless adaptor, then the zone panel is the host (up to 3 thermostats per HZ322
and up to 4 thermostats per HZ432).
For assistance with this product please visit http://customer.honeywell.com
or call Honeywell Customer Care toll-free at 1-855-Red-Link (855-733-5465)
® U.S. Registered Trademark.
Copyright © 2016 Honeywell International Inc.
All rights reserved.
Need Help?
Installation
Instructions
69-2563EFS-03
Tabla de contenido
loading

Resumen de contenidos para Honeywell RedLINK THM6000R1002

  • Página 9: Instrucciones Para La Instalación

    HZ432). ¿Necesita ayuda? Para obtener ayuda sobre este producto, visite http://customer.honeywell.com o llame de manera gratuita al Servicio al cliente de Honeywell al 1-855-Red-Link (855-733-5465) ® Marca comercial registrada en los EE. UU. Copyright © 2016 Honeywell International Inc.
  • Página 10: Instalación

    Puerta de acceso a Internet THM6000R1002 RedLINK™ Instalación Paso 1 Conecte el cable de alimentación a la puerta de acceso a Internet RedLINK. Paso 2 Conecte el adaptador de corriente al tomacorriente de pared. Paso 3 Conecte un cable Ethernet desde la puerta de acceso a Internet RedLINK al enrutador residencial conectado a Internet.
  • Página 11: Comportamiento Del Indicador Led

    Puerta de acceso a Internet THM6000R1002 RedLINK™ Comportamiento del indicador LED Indicador LED de energía activada Verde fijo: La puerta de acceso está encendida. Indicador LED de Internet Internet RedLINK Power ™ Rojo sólido: No hay ninguna conexión Ethernet (el M32855 cable está...
  • Página 12: Información Regulatoria

    Automatización y control desenlace Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 http://customer.honeywell.com Patentes en trámite ® Marca comercial registrada en los EE.UU. © 2016 Honeywell International Inc. 69-2563EFS—03 M.S. Rev. 10-16 Impreso en EE. UU.

Tabla de contenido