Using The Appliance; Maintenance - Bertos PLE80BE Manual De Instrucciones

GB
Warning!
- Beware of inexpert handling!
- Never leave the appliance on without water!
Ignition
Check that the drain valve is closed and turn the water
filler valve located on the left of appliance control panel
anti-clockwise. To ensure correct working there must be
a continual flow of water of reinstatement water of reinstatement.
To start the appliance, turn the simmostat control knob
clockwise; the appliance is set at "off" when "O" is aligned
with the coloured mark above the knob. Temperature
regulation is possible by rotating the knob clockwise
from minimum to maximum settings (see graduated
symbol; maximum = continuous operation). An indicator lamp
lights to show that the resistance is connected. The lamp
switches on and off intermittently during normal operation.
Emptying the bath
First of all a suitable bowl for emptying the water into
should be found.
Fit the drainage pipe as shown in the picture (1). Open
the oil drain tap.
Important
With Top models, make sure you respect the
distance between the appliance and the edge of the
base.
1

USING THE APPLIANCE

ELECTRIC WATER GRILL 9
CLEANING AND TAKING CARE OF THE
MACHINE
Warning!
Never clean the appliance with jets of water, whether
direct or pressurised.
Allow the machine to cool down before cleaning.
Before starting to clean the appliance, disconnect from
the mains.
All steel parts should be washed in warm water, using a
neutral detergent, then rinsed thoroughly to eliminate
any residual detergent.
Dry using a dry cloth. Avoid using abrasive or corrosive
detergents which could damage the steel.
What to do if not using the appliance for a
long time
Thoroughly clean and dry the machine as described.
Disconnect the power supply.
What to do if something goes wrong
If anything goes wrong, immediately turn the appliance
off, then turn off the power supply at the switch located
upstream of the appliance, and call the aftersales
department.

MAINTENANCE

All maintenance should be carried out by qualified
personnel only. Before carrying out any maintenance
work, unplug the appliance or turn off the switch
upstream of the appliance.
MAX 120 mm