Reese 65008 Manual De Instrucciones

Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: K65008
Wrenches: 15mm, 16mm
Drill Bits: None
1
Qty. (6) Hex Bolt, M10 x 1.50 x 30
1. If present, remove steel skid shield and return to vehicle owner. If present, remove plastic underbody panel and return to
vehicle owner.
2. Remove the forward attachment bolts in the vehicle crossmember.
3. Raise receiver into position and fasten as shown above.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Jeep Grand Cherokee
Bumper
Frame
Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft (52 N-m).
CARGO CAPACITY – DO NOT EXCEED
300 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Existing Weldnuts
Remove Existing
Fastener
Recovery Eye
2
Qty. (6) Conical Washer, 7/16"
Sheet 1 of 3 N65008
Part Numbers:
65008
LB. MAX. WINCH LINE PULL
Vehicle Crossmember
11-07-05 Rev. A