Connecting Cables - Epson Tm-L90 Manual Del Usuario

4. Insert the screw included with the spacer into the hole indicated
below and tighten it. (Even if you can see two holes, this is the only
one to put the screw in.)

Connecting Cables

To connect cables, first remove the bottom
of the cover as shown in the illustration.
To place cables, first break off by hand any
of the three portions indicated by circles in
the illustration (the other portion is on the
right). Then put the cables through the
holes and replace the bottom of the cover.
hole for screw
TM-L90 User's Manual 9
English