Stroller Assembly - Lionelo Emma One Manual De Usuario

PRODUCT PART DESCRIPTIONS (FIG. B)
1.
Canopy
2.
Folding system x2
3.
Caregiver handle
4.
5-point harness

STROLLER ASSEMBLY

1.
To unfold the stroller, gently release the lock on the side of the stroller frame (Fig. 1).
2.
Hold the caregiver handle and lift it vigorously upwards to open the stroller (Fig. 2). A clicking sound
indicates that the stroller frame is fully open (Fig. 3).
3.
To fit the front wheels, insert the pin into the corresponding holes on the front of the stroller frame
(Fig. 4). Pull on the wheel to check that it is securely attached. To remove the wheel, press the release
button above the wheel (Fig. 5).
4.
Move the straight-ahead wheel locks outward (Fig. 6) to secure the front wheels in place, preventing
them turning to the right or left. Slide inwards to unlock (Fig. 7).
5.
Slide the rear wheels onto the rear axle (Fig. 8).
6.
Insert the washers and wheel clips into the designated holes (Fig. 9) and press the blanking plugs (Fig.
10). Pull gently to make sure that both wheels are securely fastened.
7.
Mount the rear axle with wheels onto the stroller frame (Fig. 11). Make sure that the parking device
is facing outward. Ensure that the metal tabs are in the correct holes. A clicking sound indicates that
the elements are mounted correctly.
8.
To remove the rear axle, press the metal tabs on both sides inward and then pull it out.
9.
To install the tray, grasp it with both hands and slide it into the guides on both sides of the stroller
(Fig. 12). A clicking sound indicates that the element is properly fastened. Pull gently to ensure that
the tray is installed correctly.
10. To remove the tray, press the buttons on both sides of the tray and lift the tray upward (Fig. 13).
STROLLER FRAME FOLDING
Before folding the stroller, make sure to fully fold the canopy, remove the tray, and adjust the backrest to
the most horizontal position.
To fold the stroller, press both frame folding buttons on the caregiver handle at the same time (Fig. 14).
Press the handle down. The frame folds itself, and the folding lock engages automatically.
CANOPY ADJUSTMENT
To adjust the canopy, pull it in the desired direction (Fig. 15).
Unfasten the zip in the centre of the canopy to expand the range of adjustment.
FOOTREST ADJUSTMENT
To adjust the footrest, press the adjustment buttons on both sides and push the footrest down (Fig. 16).
To raise the footrest again, pull it upward.
5.
Locking device
6.
Rear wheel
7.
Front wheel
8.
Footrest
‑ 9 ‑
9.
Tray
10. Storage basket
11. Parking device
12. Straight-ahead wheel lock
EN