AeonAir RDH60EB-1 Manual De Usuario página 9

OPERATING INSTRUCTIONS
START OPERATION
1. Place the product in an upright position on a flat, stable, and
heat-resistant surface. Make sure there is noth ing flammable or
heat sensiti ve within 39 inch ( 1 OO c m). Operating the produ ct in
any other position could cause a hazard .
2. Insert the plug into a su itable wall socket. The dehum idifier is
suita ble fo r operating on an electri city supply havi ng the same
voltage as that shown on its rating label.
3. Make sure the water tank is correctly located. After switching on
the machine for the first time, if the "Bucket Full" light illuminates,
pull out the water tank and check that the "float" lever is able to
move freely, then return the water tank to the correct position (Fig . 1 ).
Float lever
WATER FULL INDICATOR LIGHT (RED)
When the water tank is full and/or incorrectly positioned inside the cabinet, the water full red light
turns on and remains on until such time that the tank is emptied and/or correctly re-positioned.
This condition will result in the immediate shut down of the dehumidifying system (both compressor
and fan motor operations are terminated ). This is a safety feature . When the water tank is emptied
and/or correctly re-positioned , the dehumidifier will resume operation automatically.
NOTE: It may take several minutes before operating conditions resume.
BUCKET FULL LIGHT
• When the water tank is full the machine will stop and the" Bucket
Full" light will illuminate.
• The water tank should be carefully removed from the machine by
sliding it outward from the front of the unit and it should be emptied .
When the empty tank is replaced properly in the machine, the unit
will start up and run normally (Fig. 2).
NOTE: Please use both hands to carefully empty the water tank.
FACTORY DEFAULT SETTING
Humidity Setting : 30% Fan Speed: Low
NOTE: In the event of a power failu re, the unit will default to the last program setting that was used
when power is restored (does not include TIMER setting).
WATER TANK OPERATION
Proper installation of the water tank is crucial in maintaining reliable dehumidifier operation . The
water tank holds accumulated condensed water and , by means of a safety switch, controls both
the water level and operation of the dehumidification process. When the water tank is full and/or
accidentally displaced inside the cabinet, the float switch actuator (inside the tank) breaks contact
with the safety switch. This condition results in the immediate shut down of the compressor and fan
motor system, preventing moisture from being condensed .
NOTE: Never tamper with or attempt to defeat the water level (safety) float switch system.
9