OPERATING INSTRUCTION
EN
INSTRUKCJA OBSŁUGI
HAND BLENDER BL230
FAN HEATER HL12
• GENERAL DESCRIPTION
1. Speed controller
2. On/Off switch I
3. On/Off switch II - TURBO
4. Body
5. Crushing tip
•
INTENDED USE
The BL230 hand mixer is designed for, among other things, the preparation of creamy soups and nutritious smoothies.
The speed of the appliance is set using the handy controller, and by changing its position, 12 different speeds
can be selected. The TURBO button is used to instantly reach the highest speed.
• OPERATION
After unpacking the device, make sure that it has not been damaged in transit. If in any doubt, refrain
from using it until you contact a service center.
Speed settings
Using the controller (1), adjust the speed of the appliance. By adjusting the regulator, it is possible to obtain
12 different speeds. The appliance starts working after pressing and holding the switch (2).
The TURBO button (3) is used to immediately obtain the maximum rotational speed corresponding to the
position "12" of the controller (1).
The crusher works as long as the on / off switch (2 or 3) is pressed.
• USE
Before first use all components outside the body must be thoroughly washed and dried
(see: CLEANING AND MAINTENANCE).
NOTE The temperature of the products being processed must not exceed 60
- Put the tip (5) on the body (4) and lock it (fig. 2) - make sure the tip is properly seated.
- Immerse the blade in the mixed (crushed) liquid completely.
- Select the appropriate speed using the controller (1) and press the button (2 or 3).
- Crush the ingredients in circular movements until the desired consistency is obtained.
- When finished working, detach the tip (5) from the body (4) - fig. 3.
When mixing (grinding) hot liquids, be careful not to overheat the tip (5).
The crusher cutter (5) is very sharp. It can be touched only when the appliance is disconnected from
the mains and stopped.
• CLEANING AND MAINTENANCE
- Disconnect the unit from the mains before cleaning.
- No components are suitable for washing in dishwashers.
- Do not immerse in water.
- Do not clean the appliance with sharp, abrasive cloths or sponges as you can damage the appliance
this way.
- The crusher (5) must not be completely immersed in water. Complete immersion of the elements in water
may damage them and void the warranty.
- The crusher (5) should be detached from the body (4) for cleaning. Clean them with water and some
washing-up liquid. Only the cutter tip and the whisk tip can be immersed.
- The body (4) can be wiped with a damp cloth.
The chopper tip knife (5) must not be cleaned with bare hands. Use a toothbrush for cleaning.
10
• TECHNICAL DATA
− rated power: 800W
− maximum power (MBP): 1500 W
− supply voltage: 220-240V~ 50-60Hz
− maximum time of continuous operation: 1 min
− period of interval before re-use 1 minute
o
C.