SolarLine 313166 Instrucciones De Utilizacion página 3

A: Main Unit B: Solar Panel
Information: Before installing a solar lamp motion sensor to please the rain CPU but is aware that the solar panel is
waterproof. Choose the best location for your panel, put it in a place where sun exposure is greatest during the day.
Start:
After installing your solar lamp, please ensure that you put in the solar charger to sunlight for at least 3 days before turning
on the light so that it can operate on a maximum load. Therefore if you want to use your lamp, set the switches ON and
AUTO.
Adjustment of the motion sensor:
You can adjust the sensitivity A motion sensor and the lighting time "B" (see photo against)
1) Time Lighting: You can adjust the time - to +: 30sec to 5
minutes.
2) Sensitivity: You can adjust the sensitivity of your detector -
to +. If you set up (+); your lamp detect approximately 10m. If
you set a minimum (-), it can detect only about 4m.
SOLAR LAMP WITH MOVEMENT DETECTOR 3LED
Instruction Manual
B
Réf 313166
A
313166
A
B
100°
GB