Control Options; Unit Status; Operation Modes; Dhw Control - Airzone Aidoo Pro Aerotermia Azai6Wsppa2 Guía Rápida

Control options

UNIT STATUS

The status of the water circuits can be controlled in water supply temperature mode, in
room temperature mode and in instantaneous domestic hot water production control mode
("Powerful" function) by means of an external wired contact.

OPERATION MODES

The modes that can be selected from the device are: Cooling mode, Heating mode and Auto
mode.
If the unit is operating in Auto mode, its operation will depend on the outdoor temperature and
the thermostat room temperature.

DHW CONTROL

The manufacturer's units allow you to manage domestic hot water (DHW) production status
control. The "Powerful" function can be activated in DHW production status control, which
forces the DHW to reach a temperature that has been preset in the configuration of the unit. If
DHW is turned off, it will not be possible to activate this parameter.

WORKING SETTINGS

The manufacturer's units can operate in both room temperature mode and in water supply
temperature mode.
The Aidoo device can regulate the temperature in one or two circuits, both in room
temperature mode and in supply temperature mode.

SET-POINT TEMPERATURE

The unit temperature will depend on the working settings:
•
In room temperature mode, the thermostat room temperature will be selected, and in
supply temperature mode, the water supply temperature at which the unit is to operate will
be selected.
•
The DHW temperature can be selected within the ranges set by the unit's own main
thermostat.
The temperature limits can be obtained via protocol for room temperature mode, supply
temperature mode and DHW production status control. The maximum DHW temperature
range value can be selected, but the minimum value cannot be configured.
EN
11