Panasonic CQ-DVR909U Manual De Instrucciones página 57

O Before Installation
Be sure to remove the Shipping Brackets ©. @ Shipping Bracket
Y)
e The shipping brackets are sometimes used
when installing the power amplifier unit. Do
not discard the shipping brackets.
O Power Amplifier Unit
© Power Amplifier Using Velcro Tape @, secure the Power Amplifier
Unit Unit @ underneath the passenger seat.
e Affix the adhesive-backed Velcro Tape @) to the
bottom of the power amplifier unit, and then place
the unit on the carpet under the seat.
Pass the cords Note:
under the carpet. e Velcro Tape © de not adhere to some types of
@) Velcro Tape carpet.
Carpet
When using the shipping bracket @
2 Tapping screws (Option) O Using a Binding Screw @, attach a Shipping
(5 mmpx16 mm) \ @ Power Amplifier _ Bracket © to the Power Amplifier Unit @.
=. © Drill two 3.5 mm holes in the body of the car in
@ Binding Screw alignment with the holes in the Shipping Bracket
(5 mmgpX12 mm) |
©.
© Use 2 Tapping screws to attach the Power
Use a knife or Amplifier Unit @ to the car.
other cutting
tools to open
2 cross-shaped
@ 1 Shipping
Bracket
Apply anti-corrosion treatment
cuts in the carpet. to the 2 Tapping screws
. and the 2 holes.
Cautions:
e Continuous use of this unit will cause the power amplifier unit to become hot. Be careful not to
touch the power amplifier unit while it is in operation. Also, do not place other objects on top of
the power amplifier unit.
e Do not install the power amplifier unit in a location where it may be subject to damage from
overheating, such as next to a heater vent, or in a location exposed to direct sunlight such as the
dashboard or the rear window deck.
e Do not install the power amplifier unit near a door or other locations where it may be readily
exposed to water or stepped on.
e Clean away all oil, moisture, dust, etc., from the surface where the velcro tape is to be applied.
e When drilling holes in the car, make certain that you do not damage any pipes or wiring on the
underside of the car.
e When installing the power amplifier unit, make sure that the cord is positioned in a location where
it will not be pinched or damaged when the seat slides forward or backward.
57
CQ-DVR909U
T7