Uline H-11258 Manual Del Usuario

H-11258, H-11259
π
H-11260, H-11261
MODULAR DRAWER
WORKBENCHES
TOOLS NEEDED
Drill Phillips Head
Drill Bit
Tabletop x 1
M6 x 16 mm Hex Bolt x 2
NOTE: It is recommended to position the
cabinet in its final location prior to assembly.
ISLAND ASSEMBLY (FOR H-11260, H-11261)
1. Align the two 29" wide cabinets and push together
so that they touch. (See Figure 1)
Figure 1
PAGE 1 OF 9
1-800-295-5510
uline.com
Ratchet with Allen Wrench
10 mm Socket (included)
29" Cabinet x 2
(for H-11260, H-11261)
M6 Flange Nut x 2
ASSEMBLY
PARTS
OR 22" Cabinet x 2
(for H-11258, H-11259)
ST6.3 x 25 mm
Wood Screw x 12
2. Remove top drawer of each cabinet by fully
extending drawer and pulling the gray tabs toward
the front of the drawer on each side. Once tab is
pulled out, flip it up. This will release the drawer
allowing user to pull it out from slides. (See Figure 2)
Remove drawer slides from cabinet at this time.
Figure 2
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
Support Bracket
(x 2 for H-11260, H-11261)
(x 4 for H-11258, H-11259)
M6 x 20 mm Bolt x 16
1123 IH-11258