Axxess AXDIS-TY1 Instrucciones De Instalación

INTERFACE COMPONENTS
• AXDIS-TY1 interface
• AXDIS-TY1 harnesses (LD-TYNOAMP, LD-BX-TY2 AND LD-2NAVAMP)
• Female 3.5mm connector with stripped leads
TOOLS REQUIRED
• Wire cutter • Small flat-blade screwdriver
• Crimp tool • Connectors (example: butt-
• Solder gun
• Tape
AxxessInterfaces.com
Lexus/Toyota Interface with SWC
INTERFACE FEATURES
• Designed for both amplified and non-amplified models
• Provides accessory power (12-volt 10-amp)
• Retains audio controls on the steering wheel
• Provides NAV outputs (parking brake, reverse)
• Retains the factory AUX-IN jack
• Retains balance on amplified models
(non-amplifed models will retain balance and fade)
• Micro-B USB updatable
APPLICATIONS (See Page 2)
connectors, bell caps, etc.)
Visit AxxessInterfaces.com for more detailed information
about the product and up-to-date vehicle specific applications.
© COPYRIGHT 2024 METRA ELECTRONICS CORPORATION
AXDIS-TY1
I N S TA L L AT I O N I N S T R U C T I O N S
2002-2015
TABLE OF CONTENTS
Applications ...........................................................2
Connections:
Non-Amplified Models: LD-TYNOAMP .................3
Amplified Models: LD-BX-TY2 .............................4
3.5mm Jack Steering Wheel Control Retention ....5
Installing the AXDIS-TY1 ........................................5
Programming the AXDIS-TY1 ................................6
Audio Level Adjustment .......................................6
Steering Wheel Control Settings .....................7-10
LED Feedback .......................................................7
Changing Radio Type ..........................................8
Remapping the SWC Buttons .........................8-9
Dual Assignment Instructions ........................... 10
Troubleshooting.................................................... 11
Product Info
ATTENTION: With the key out of the ignition, disconnect
the negative battery terminal before installing this product.
Ensure that all installation connections, especially the air
bag indicator lights, are plugged in before reconnecting the
battery or cycling the ignition to test this product.
NOTE: Refer also to the instructions included with the
aftermarket accessory before installing this device.
REV. 4/22/24 INSTAXDIS-TY1