Manual Operating Instructions; Display & Buttons; Crumpled Tube Detection; Hopper Notification - RF Tech Powermatic V Manual Del Usuario

MANUAL OPERATING INSTRUCTIONS

1
To switch off the automatic
tube feeder and manually fill
tubes, open the tube hopper
lid.
DISPLAY & BUTTONS
Resettable Counter
1
Total Counter
2
Counter Reset Button
3
Density Adjustment Button
4

CRUMPLED TUBE DETECTION

If a tube misses the spoon nozzle, the machine detects that a new tube has not been
inserted and the tube feeder will return to the start position. Remove crumpled tubes
and press START to resume the automatic feeding.

HOPPER NOTIFICATION

Two possible causes. 1. Tobacco is low. Before adding new tobacco, keep tobacco
hopper lid closed and push START to push residue out of loading chamber. Hopper
message clears from display, open lid, add tobacco, close lid and push START to
continue filling tubes. 2. Tobacco does not drop. Make sure volume tobacco is used.
The tobacco may be too cohesive and need to be processed before use. Shorten the
tobacco cut, check the moisture level and dry it to below 12% rH if needed.

JAM NOTIFICATION

If the spoon blocks, the display shows JAM. Switch off the machine and use the
cleaning probe through the spoon nozzle to remove tobacco residue in the loading
chamber. Open the lid and remove remaining tobacco residue in the hopper. After
all residue has been removed, you can switch the machine back on and press START.
2
Place an empty tube over
the spoon nozzle and press
START.
High
Medium
Standard
4
3
Manual filling of the
cigarette is complete.
1
2
3