Heating Element - Calorex Pro 40 L Instructivo De Instalación, Operación Y Mantenimiento

20 / EN
• To fill the heater, open the supply valve on the cold-water supply pipe. Open a hot water
tap slowly (preferably the shower) to allow air to exit the heater and the pipe. A continuous
water flow at the hot water tap indicates that the heater is full of water.
VI.- ELECTRICAL INSTALLATION
CAUTION:
because it is a dangerous procedure.
Electric Diagram
Ground
Neutral (N)
IMPORTANT:
from the manufacturer or its authorized service agent.
the electrical installation must be carried out by a Calorex Service specialized technician
Line (L)
Thermostat
Swith
Pilot lamp
if the power cord is damaged, it must be replaced by a special cord or assembly available

Heating element