Machine Specific Instructions; Technical Data; Noise; Cleaning And Maintenance - Powerplus Powdp50700 Traduccion Del Manual De Instrucciones Originale

CAUTION: Adjust the speed selector only within the range of numbers 1
through 6. Do not force the dial beyond this range or damage to the tool may
result.
WARNING: Avoid blocking the vent holes, as this may cause the eccentric
sander to overheat.
WARNING: To prevent accidents, turn off the tool and disconnect the battery
after use. Clean and store the tool indoors and out of children's reach.
11.4

Machine specific instructions

▪
Secure the work piece to prevent it from moving under the sander belt.
▪
When starting or stopping the machine, do not let the tool contact with the work piece.
Otherwise, it will result the in damage of the sander belt or it will make the machine
getting go out of control.
▪
When operating the machine, be careful to avoid any part of your body to come into
contact with any of the moving parts of the machine or belt.
▪
Avoid contact with the sanding belt at any time

12 TECHNICAL DATA

Rated voltage (DC)
Variable speed
Working bar length
Sanding belt size
Sanding surface
Engine type
Soft grip

13 NOISE

Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration)

14 CLEANING AND MAINTENANCE

▪
Remove the battery pack from the tool before carrying out any adjustment, servicing or
maintenance.
▪
The machine does not require any special maintenance.
▪
For safe and efficient working, always keep the machine and the ventilation slots clean.
▪
Always be sure that the tool is switched off and unplugged before carrying out any work
on the tool.
Copyright © 2022 VARO
POWDP50700
20 V
360 – 800 m/min
110mm
13x457mm
13 mm
Brushed
Yes
81 dB(A)
92 dB(A)
3,4 m/s²
P a g e | 9
EN
K = 1.5 m/s²
www.varo.com