GYS GYSFLASH 18.12 PL Manual De Instrucciones

LEAD-ACID/LITHIUM
GYSFLASH 18.12 PL
BATTERY CHARGER
AND BATTERY
SUPPORT UNIT
12 V Ref. 026926
With a power of 18 A, the GYSFLASH 18.12 PL is a smart charger designed to charge 12 V lead-acid and
lithium batteries. It can also be used as a Battery Support unit and its «Showroom» mode enables to safely
support and maintain showroom vehicle batteries.
DUAL TECHNOLOGY: LEAD-ACID & LITHIUM
• High performance, 18 A duty cycle at 100% (40°C).
• 2 charging modes :
: designed for every 12 V lead-acid batteries from 15 Ah to 270 Ah.
: designed for lithium iron phosphate batteries from 7 Ah to 270 Ah.
• 3 charging currents: 7 A, 12 A and 18 A. The user can select the charging current
according to the technology and capacity of the battery.
• Showroom mode
accessories of a demonstration vehicle and during the diagnostic phase.
• Supply mode, provides a stabilised power supply so the GYSFlash 18:12 PL can be used
as a Battery Support unit:
- this mode can also be used during a battery change to preserve the vehicle's memory.
• Optimised maintenance charge, the charger can safely remain connected indefinitely, for
example during winter, to maintain the health of the battery. The «Auto Restart» function
means that the charger will memorise the settings and restart automatically in the event of
a power cut.
• Will charge deeply discharged batteries from as low as 2V.
100% AUTOMATIC CHARGE
• Extend performance and lifetime of lead-acid (gel, AGM, liquid, calcium, etc.) and LiFePO4 batteries (LFP).
• External temperature sensor, for an optimal battery charge whether it's summer or winter.
The charger adjusts its charging parameters depending on ambient temperature.
EBS technology (Equalizing Battery System) to ensure the perfect
balancing of battery cells.
SAFETY
• Protection of the vehicle's on-board electronics: protection against short circuits, polarity
reversal and overcharging. Spark prevention system.
• Automatic stand-by mode if the battery is disconnected.
• Integrated temperature sensor to prevent internal electronics' overheating.
• Simplified interface to prevent user errors.
ERGONOMICS
• Compact design, light and portable.
• IP43 : outdoor use
• Option (with calibration): 6 m cable (ref. 027435)
• Can be wall mounted, optional magnetic system available (ref. 026063).


Icharge
50 / 60 Hz
220-240 V AC 300 W 7/12/18 A
- EN 60335-2-29
, ensures current compensation up to 18 A when using electrical


V
Charge / Maintenance
Pb 15 < 270 Ah
12 V
LiFePO 7 < 270 Ah
4
Specific 7 step charging curve for each battery technology. Can
be safely left connected without supervision.
Specific charging curve in 8 steps without supervision.
«UVP* Wake up» function: reactivates a battery in
protection after a deep discharge and automatically starts the
charge.
*UVP : Under Voltage Protection

Ondulation/ Charging
Ripple curve
7 step
<0.5 Ah/ <100 mV
IU U
month Rms
0
8 step
START / STOP
(EFB/AGM)
Supplied with:
ref. 026094
 

kg mm mm
190 x 190 193 x 260 Automatic
1.55
x 95 >2V
x 73
MADE in FRANCE
www.gys.fr
Clamps
(1.9 m)
 
IP
IP 43 2 m