Vaxcel T0736 Manual De Ensamblaje E Instalación

ASSEMBLY AND INSTALLATION
T0736
WARNING: Turn off the main power at circuit breaker before installing fixture.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
Important to Know
1. Read all instructions carefully before installation and
operation.
2. If you are not familiar with state and local electrical codes,
it is recommended that you consult with a qualified
electrician.
3. Before installation, shut off power at the main fuse or
circuit breaker box. Be aware that simply turning off the
wall switch is not sufficient to prevent an electrical shock.
4. This fixture requires a 120V AC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge,
make sure the ground wire is securely connected.
7. For general safety and to avoid any possible damage to
the sensor, be sure the power is switched "off" before
replacing the bulb.
8. Compatible with most LED dimmable bulbs.
Maximum Wattage: 60W Bulb
Working Temperature: - 22°F~113°F
Outlet Box
House Ground Wire
Wire Connector (C)
Crossbar Unit (A)
Fixture Mounting Screw
Green Ground Screw
Mounting Screw (B)
Fixture Ground Wire
Fixture Wire
Backplate
INSTRUCTIONS
Page 1 / 5
Features
1. Energy saving fixture.
2. When in manual override mode, use wall switch
to keep the light ON till dawn.
Hardware Package (included)：
Crossbar Unit (A) Mounting Screw (B)
Wire Connector (C) Bolt Nut (D)
Max. 60W Type A Bulb
(not included)
Rubber Pad (E)
Rubber Pad (E)
Bolt Nut (D)
231013