ASPEQ 908 Serie Instrucciones De Instalación, Operación Y Mantenimiento

908X Series
Commercial / Industrial
Slope Top Convector
- NEMA 4X Rated
Installation, Operation & Maintenance Instructions
CAUTION - TO REDUCE RISK OF FIRE AND ELECTRIC
SHOCK OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. Read all instructions carefully before using this heater. This
instruction sheet contains vital information for the proper
installation, use, and efficient operation of the heater.
Carefully read the manual before installation , operation or
cleaning of the heater. Failure to adhere to the instructions
could result in fire, electric shock, death, serious personal
injury, or property damage.
2. It is recommended that drapery be kept a minimum of four
(4") inches from the top or front of heater.
3. This heater is not intended for residential use.
4. The heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces.
5. A heater has hot and arcing or sparking parts inside. To
reduce the risk of fire, do not store or use gasoline or other
flammable vapors and liquids in the vicinity of the heater.
ECR 03005
IMPORTANT INSTRUCTIONS
WARNING
SAVE THESE INSTRUCTIONS
!
6. To prevent a possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft surfaces, like a
bed, where openings may become blocked.
7. To reduce the possibility of electric shock, it is recommend-
ed the power to the heater be disconnected during wash
down.
8. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or
fire, or damage the heater.
9. Supply voltage must be the same as heater voltage. Check
heater nameplate and supply voltage before energizing.
10. Supply wiring must be rated minimum 75ºC. Use copper
wire only.
11. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
01/24
ENM-4080-00