Assembly - Attaching The Fan Blades; Attaching The Fan Blades - Hampton Bay Scenic Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
5
Attaching the motor housing
□
Align the three holes on the top of the motor housing C)
with the three holes on the mounting plate (A). Push the
motor housing (C) up.
□
Install the three screws that were removed in step 1 into
the three holes and tighten all screws firmly.
6
Attaching the center band to
motor assembly
□
Fasten the center band (D) to the motor housing (C)
by inserting the alignment posts into the slot on the
bottom of the motor housing and tightening the four
pre-installed screws (DD).

Assembly - Attaching the Fan Blades

1

Attaching the fan blades

□
Attach a blade (E) to the fan-motor assembly by inserting the
blade (E) into the slots in the side of the fan center band (D)
and aligning the three screw holes in the blade with the holes
in the center band and secure with screws (AA).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
DD
9
Please contact 1-855-HD-HAMPTON for further assistance.
A
C
B
C
D
C
D
E
AA
HAMPTONBAY.COM