Installation And Assembly - Pinnacle Climate Technologies MASTER MAC-20FOMNI Manual Del Usuario E Instrucciones De Operación

1. Place the fan on level ground in a safe, desired position then connect to an approved power source.
1.Align cradle base with support brackets
attached to fan body sides. Note: you may need
to flex the parts to make them align properly.
2.Insert support bracket into opening of cradle
base. Press spring loaded button down to allow
it to insert into cradle base, see Fig.1.
3.Press support bracket into cradle base until
spring button protrudes out open hole in cradle
base, see Fig. 2.
4. Repeat above process for opposite side of fan.
1. Align the screw hole on the side of the fan head with both the rubber ring
and the hole on the support bracket; springloaded button of the support
bracket is facing the fan, see Fig. 9.
2. Insert the screw knob and tighten up.
3. Repeat above process for opposite side of fan.
4. Align Cradle Base (packed separately) with support brackets attached to
fan body sides. Note: you may need to flex the parts to make them align
properly, see Fig 1
5. Insert support bracket into opening of Cradle Base. Press spring loaded
button down to allow it to insert into Cradle Base, see Fig 2.
6. Press support bracket into Cradle Base until spring button protrudes out
open hole in Cradle Base, see Fig. 2.
7. Repeat above process for opposite side of fan.
© 2021, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING OR WHILE
CONNECTED TO A POWER SOURCE

Installation and Assembly

MAC-12F
MAC-20F
Fig. 1
MAC-20FOMNI
3
Fig. 2
Spring
Button
Cradle
Base
Rubber
Ring
Fig. 9
High Velocity Fan User's Manual
Support
Bracket
Spring
Button
Screw
Knob
Support
Bracket