Maclean Energy MCE992 Manual Del Usuario

-20-
Target indicator
DISC/
NOTCH
Sens/
Signal
Disc
Low Menu Target
numeric
indicator Batt Content numeric indicator
Metal Detector
EN
Please read before using the detector! With your metal detector, you can hunt for coins, relics, jewelry,
gold, and silver just about anywhere. The detector comes with high sensitivity and strong ability of
discrimination. It is versatile and easy to use.
The detector's features include: LCD Display: Shows the probable type of metal, the depth of the target,
range of DISC & NOTCH, the level of SENS, and battery condition. It also has numeric display for target.
Three Tone Audio Discrimination: Sounds three distinctive tones (high, medium and low) for different
types of metal. Notch: Ignores junk metal and finds valuable items by setting the notch range. DISC:
Discriminates the unwanted target by setting the DISC numeric range. The detector will not detect the target
beyond the numeric setting. LIGHT: Used in dark area. PP: Pinpoints the location of the target accurately.
Super Slow Sweep Identification: With a very slow sweep of the search coil to discriminate different types
of metal. Headphone Jack: Lets you connect headphones (not supplied) of 3.5mm and operate without
trouble. 250mm Waterproof Search coil: Lets you use the detector even if you must put it under shallow
water. Adjustable Shaft: Lets you adjust the length of shaft for comfortable use. Power: Your metal detector
requires two 9-volt alkaline batteries (not included).
PREPARATION: ASSEMBLING THE DETECTOR
Assembling your detector is easy and requires no special tools. Just follow these steps:
1. Insert the latch on the top of the handle into the assembly hole on the bottom of the control box. Then
slightly push the control box in the direction of IN marked on the handle to fix the latch in place. Secure the
control box with fixing screw properly.
2. Unscrew the fixing knob on the search coil and remove the knob connector. Place the washers into the
groove of the lower stem. Then insert the stem and align the holes on the search coil bracket and the stem.
Push the connector through the holes and tighten the knob.
3. Press the silver button on the upper end of the lower stem, and slide the lower stem into the upper stem.
Adjust the stem to a length that you feel comfortable when you stand upright with the detector in your hand,
and the search coil is level with the ground with your arm relaxed at your side. Then counter-clockwise
MCE992
Power/
Headphone Menu PinPoint Notch Volume
-01-