AENO DI2 Manual De Instrucciones página 15

Preparing the device for operation
Unpack the device. Wipe its casing with a cloth slightly soaked with water, then
rub it dry. Detach the water tank (see fig. f). Rinse and dry the water tank and
all the nozzles as described in the "Maintenance" section ("Daily care").
Charging the device
WARNING! The power adapter is not included in the package. You can use any
power supply (adapter, portable charger, etc.) as long as it ensures 5 V (DC) ,
2.0 A power parameters.
Connect the device to the power supply as shown in figure d. Battery charge
indicator (6) statuses during charging:
 the device is charging: the indicator is blinking;
 the device is fully charged: the indicator is glowing steadily.
When charging is completed, unplug the device, disconnect the cable (12) and
close the USB port (8) by firmly inserting the protective plug.
Battery charge indicator (6) statuses during operation:
 less than 10 % charge – the indicator is blinking, the device does not turn on;
 10–100 % charge – the indicator is glowing steadily.
Attach one of the replaceable nozzles (13–15) to the casing by pushing it until it
clicks into place. The nozzle can rotate 360°.
The intended use of the irrigator nozzles (figure c):
(13) – a standard nozzle for removing food debris and plaque;
(14) – an orthodontic nozzle for braces and dentures;
(15) – a nozzle for cleaning periodontal pockets.
Fill the water tank (2) as shown in figure g. Close the cap of the water filling
hole (10) tightly. After that, proceed to select the operating mode of the device.
Selecting the device operating mode
NOTE. To set the operating mode, point the nozzle outlet in a safe direction so
that the water jet does not damage the surroundings and you can see the
mode selection panel (5).
aeno.com/documents 15