Remove Functional Part; Fault Correction - KWC AQRM559 Instrucciones De Montaje Y Uso

12. Remove functional part

12.1 Remove the sealing cap.
12.2 Remove the safety ring.
12.3 Remove the pressure cap and spring.
12.4 Use a socket spanner to unscrew the functional part.
12.5 Reassemble in the reverse order.

13. Fault correction

Fault
Water does not flow
at all
Water flows conti-
nuously
Water flow too weak
Water flow too large
If you are unable to correct a fault or if the fault is not described in the fault correction
section, please inform the AQUA service department.
6
Cause
– Water supply interrupted
– Flow volume regulator closed
– Functional part faulty
– Functional part faulty
– Volume flow rate controller is closed
– Flow volume regulator not fully
opened
– Supply pressure too low
– Volume flow rate controller not fully
opened
– Flush volume adjustment incorrect
– Flush volume adjustment incorrect
– Volume flow rate controller not fully
opened
Remedy
➯ Restore
➯ Open it
➯ Replace it
➯ Replace it
➯ Open it
➯ Open it
➯ Check it
➯ Adjust it
➯ Adjust it
➯ Adjust it
➯ Close it