Electrical Connection; Charger Appearance; Overview Of Internal Structure; Ac Wiring - FTE Univers U+ WB1-7-OCPP-LK4 Manual Del Usuario

User's manual · WB1-11-OCPP-LK7 & WB1-11-OCPP-

4 Electrical Connection

4.1 Charger Appearance

4.2 Overview of Internal Structure

4.3 AC Wiring

Note: Before insert input power wire, please cut silicon sealed loop as required to maintain IP65.
1. Remove a length of 40mm of the cable jacket and strip the wire insulation to a length of 8~15mm.
2. Crimp the terminals as shown in the figure below.
Single-phase Wiring
3. Distinguish different input wires of three-phase and single-phase, then insert the wire into the
corresponding wire slot.
Single-phase Connection
Technical changes and mistakes reserve
User's manual · U+ WB1-7-OCPP-LK4 / U+ WB1-11-OCPP-LK4
Three-phase Connection
-6- u+
User's manual · WB1-11-OCPP
Cut along this circle
Three-phase Wiring
WB1-7-OCPP-LK4 / U+ WB111-OCPP-LK4 Versión en_1.0 Univers by FTE