Product Installation; Installation Procedures - Midea MSF15AH6LB Manual Del Usuario

PRODUCT INSTALLATION

Installation Procedures

1 Remove the air inlet grille.
EN
Snap fit
release
3 Remove the protective film of the
filter.
5 Install the pre-filter.
Align the slot position at the bottom,
and snap fit the upper U-Shaped joint to
install.
2 Take out the pre-filter.
Press the raised part on both sides to
pull it outwards, and take out the
pre-filter.
4 Install the HEPA filter.
6 Install the air inlet grille.
Align the upper two snap fit joints and
press them tightly together to fasten,
then press the two sides together at the
bottom, slowly and gently snap fit the
air inlet grille into place.
07
Snap fit
position