Before The First Use; Display/Touch Button Functions - Vlectro VL-LEDPANBL2000 Manual Del Propietário

BEFORE THE FIRST USE

• Place the device on a flat stable surface and ensure a minimum of 15cm free space
around the device. This device is not suitable for installation in a cabinet or for outside use.
• Put the power cable into the socket. (Note: Make sure the voltage which is indicated on
the device matches the local voltage before connecting the device. Voltage 220V-240V
50/60Hz)
• When the device is turned on for the first time, a slight odour will occur. This is normal,
ensure adequate ventilation. This fragrance is only temporary and will disappear soon.
• During heating up and cooling down there may be some noise caused by the heater
casing expanding and contracting, this is normal and does not indicate any fault.

DISPLAY/TOUCH BUTTON FUNCTIONS

4
EN