Hitachi PC-P2HTE Manual De Instalacion Y Uso

1. SAFETY SUMMARY

DANGER:
DO NOT pour water into the remote controller
-
(hereafter called "controller"). These products are
equipped with electrical parts. If poured, it will cause a
serious electrical shock.
DO NOT operate switches by wet hand. It may cause
-
an electrical shock.
In case that the protective devices often function or
-
the operation switches do not function well, turn OFF
the main power supply and contact your service
contractor of HITACHI.
In case that other abnormalities are found, stop the
-
system, turn OFF the main power supply and contact
your service contractor of HITACHI.
2. INSTALLATION WORK
2.1. SELECTION OF INSTALLATION PLACE
Location of Remote Controller
Select a suitable place for handling and determine the
installation place of the controller with the customer's
acceptance.
Especially in case that a remote control thermistor (C8)
is used, pay attention to select the installation place.
2.2. BEFORE INSTALLATION
Check the contents and the number of the
accessories in the packing.
2 screws
Remote Control M4x16L For
Switch, for Operation fixing the
Control Holding Bracket
onto the wall
2.4. INSTALLATION PROCEDURE
1. Insert the edge of the flat head screwdriver into the dent parts at the bottom of the holding bracket, push and turn the
screwdriver and remove the controller from the holding bracket as shown in the next figure.
Dent
Part
2. Attach the controller to the holding bracket as follows.
INSTALATION AND OPERATION MANUAL FOR PC-P2HTE
INSTALLATION MANUAL FOR PC-P2HTE
1 Band.
For fixing Ring
Cable to Ring Core.
Core
Controller
Dent Part
Holding
Bracket
Screwdriver

WARNING:
DO NOT perform installation work and electrical wiring
-
connection by yourself.
In case that a service work such as repair,
maintenance, etc. is required, contact your service
contractor of HITACHI.
DO NOT modify the electrical wiring. It may cause
-
serious accidents.
NOTE:
For one remote controller, the maximum total length
of the cable (including the signal wire between units)
is 30 m when using 0.3 mm² cable and 500 m when
using the cable thicker than 0.75 mm².
2.3. INSTALLATION SPACE
In case of installing the controllers in vertical line, keep a
distance more than 50 mm between the controllers
vertically. If the distance is insufficient, the front cover of
the controller can not open wide enough
Bottom view
Dent part
Screwdriver
Holding
Bracket
More than
50 mm
Holding Bracket
Dent part
1