LUCE&LIGHT AR330500TC Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
Made in Italy
AR330500TC DMX power supply unit
WARNING!!!
Please read the following instructions carefully.
IMPORTANTE:
• Although LED runs on a very low voltage, always cut off the power supply before installing the LED light or subjecting it to maintenance.
• Class I unit: categorically needs grounding.
• This fixture must be istalled by a qualificate electrician.
• Install the device in a well-ventilated place.
• Il dispositivo in funzione genera calore.
• Unauthorised alterations or tampering of the product will invalidate all the conditions of guarantee.
• L&L Luce&Light is not resposable if its fixtures are not installed in according to local safety standards.
• Data contained in this document may be changed at any moment without prior notice and do not place L&L Luce&Light under
any implicit or explicit obligation.
Direct current dimmable electronic drivers for power LED.
Article Code
Constant current output
AR330500TC
Standards reference
EN 55015
EN 60598-1
EN 61000-3-2
EN 61347-1
EN 61347-2-13
EN 61547
VDE 0710-T14
Voltage
AC 220 ÷ 240V
Frequency
50...60Hz
Power
0 ÷ 36W
L&L Luce&Light srl / Via Trescalini, 5 / 36031 Dueville, Vicenza / Italy / T +39 0444 36 05 71 / F +39 0444 59 43 04
AR330500TC
Power supply units and control gear
60
2,36''
36
1,42''
P out V out
W DC
36 42 max. 3x500mA cost.
E lucelight@lucelight.it / www.lucelight.it
e q u i v
SELV
210
8,27''
225
8,86''
I out n° LED V out
DC max. max.
3x6 49
45
1,77''
λ max.
ta tc
Power
°C °C
Factor
-25...+45 70
η max.
Efficien-
cy
0,97 -
1/8