Oreck COMMERCIAL XL2100WMT Manual Del Usuario

1
A
C
2
D
F
Problem Possible Cause
Cleaner will not run. 1. Not plugged in properly
2. No electricity in wall outlet.
Cleaner does not pick up. 1. Filter bag is full.
2. Nozzle or intake pivot clogged.
3. Belt is broken or stretched.
4. Brush is worn.
5. Bag tube clogged
6. Bag pores are clogged with fine dust
7. Impeller fan is broken.
8. Revolving brush is not even at both ends
B
D
G
E
Possible Solution
1. Be sure cleaner is firmly plugged into wall outlet.
2. Check electrical source–fuse or circuit breaker.
1. Replace filter bag. See "To Install Paper Filter Dust Bag."
2. Clear obstruction.
3. Replace belt.
4. See "To Adjust or Replace Brush."
5. Clear obstruction.
6. Change bag.
7. Return to Service Center for repair.
8. Check brush roll end cards. Make sure words "old" or "new" match at each end.