Assemble The Shaft; Operation; Adjust The Depth Of Cut - Greenworks Tools Pac458 Manual Del Operador

WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
8.2

ASSEMBLE THE SHAFT

1. Loosen the knob (1) on the coupler.
2. Push in the release button (2) on the lower shaft (3).
3. Align the release button (2) with the positioning hole (4)
and slide the two shafts.
4
2
3
4. Turn the lower shaft until the button locks into the
positioning hole.
2
5. Tighten the knob.
Tighten
English
9
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1
1. Remove the battery pack.
2. Loosen the depth adjustment knob to increase or decrease
5
3. Adjust the depth so that the blade barely touches the
1
4. Tighten the depth adjustment knob.
5. Standing in a normal working position, check the depth of
6. Replace the battery pack once all adjustments are
Loosen
7

OPERATION

IMPORTANT
WARNING

ADJUST THE DEPTH OF CUT

the depth.
Depth Adjustment Knob
ground when the machine is held in a normal operating
posture.
cut again and correct if necessary.
complete.
Wheel
Blade
EN