Indicator Light - SPEX SLWZ-3WAY-01 Guía De Usuario

7. Turn on the power at the circuit breaker.
8. Test to see that the Smart Switch is functioning by pressing
the ON/OFF switch. Your load (lights) should turn ON/OFF
respectively.
Note: If your lights do not turn on, check that the live/load and
traveler wires are all connected according to the old switch.
Turn off power at the circuit breaker and check the wiring.
9. WiZ app setup – Refer to "WiZ Quick Setup Guide"
4-Way wiring
Hot
Mains
Neutral
Approved switch locations
Note: Only one Smart 3-way switch is required at the approved switch locations.
Note: Neutral wire required.

Indicator Light

COLOR
ON
WHITE
OFF
RED Flashing Quickly
Single Blink
WHITE
Double Blink
Note: Smart pairing mode is entered automatically once connected to power during
initial setup. Smart and Manual pairing modes can be selected within the WiZ App.
3-Way
INDICATOR LIGHT
STATUS
4-Way
SWITCH STATUS
Switch is OFF
Switch is ON
Pairing failed
Ready for Smart pairing mode
Ready for Manual pairing mode
3-Way