Mistral Sensor (Blue Bus Tds Rx); Setting The Mistral Sensor; Deleting The Mistral Sensor - Cherubini Blue Bus Tds Serie Instrucciones

It detects movements caused by the wind on the awning arms and also any accumulation of water or
snow on the fabric.
MISTRAL*- Ref. A520012
To associate the sensor to the control unit, a remote control must be already memorized. Set the selector
to the 0 position and then perform this sequence:
A
+ B
To delete the sensor from the control unit, an already programmed remote control must be used. Set
the selector to the 0 position; if active wait for the sensor to go off and then perform this sequence:
I
A
+ B
*For the complete description of the functions of this device see the instruction booklet that came in
the box.

MISTRAL SENSOR (BLUE BUS TDS RX)

SETTING THE MISTRAL SENSOR

B

DELETING THE MISTRAL SENSOR

A
37
SET BUTTON
LED
SELECTOR
set
2 sec
set
2 sec