Setting Of Additional Remote Controls (Skipper, Giro Or Pop Series); Programming The A530058 Remote Control With 4 Independent Channels - Cherubini Rx Mini Instrucciones

SETTING OF ADDITIONAL REMOTE CONTROLS
Up to 15 remote controls can be set, including the light/wind sensor.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
Tn
SETTING THE A530058 REMOTE CONTROL
The A530058 remote control must be set from another Skipper, Giro or POP Series remote
control that has already been programmed.
• Press the A and B buttons at the same time.
• The motor makes a short movement.
• Then press the B and C buttons at the same time.
• The motor makes a short movement again.
• Then, press the desired button on the A530058 remote control for at least 2 seconds.
• The motor makes a long movement.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
A
+ B
Tn
(Skipper, Giro or POP Series)
B
WITH 4 INDEPENDENT CHANNELS
B + C
+
B C
Tn
Tn
27
B
Tx (2 sec)
2
1
3 4
Tx (2 sec)