TECshow NAVIGATOR EXPERT RDM Manual De Usuario página 26

Inserting Steps
It is possible to add additional steps to chases or insert
steps at any position. If the SPEED LED lights, you can scroll
through the individual steps with the encoder wheels.
1. Activate the programming mode.
2. Press the CHASE button (button lights).
3. Select the chase to be extended with one of the
number buttons at the lower right corner.
4. The LED of the number button lights and the dis
play indicates the number and steps of the chase.
5. If necessary, use the PAGE button to switch be-
tween the memory banks 1-15 (LED A lights) and
16-30 (LED B lights).
6. You can now add an additional step to the chase.
Simply create a scene or call a scene previously
memorized. Shortly press the REC button to
memorize the revised chase.
7. To confirm the memory procedure, all LEDs of the
controller flash three times and the display in-
creases the number and steps by one step.
8. To insert a step between two steps press the
MENU/ESC button (control LED lights). Then select the
step after which a new step is to be inserted. Create the
desired scene or call a scene previously memorized and
press the REC button to memorize the revised chase.
9. Repeat the steps 4 or 5 to add or insert further
steps. To delete a step select it with one of the encoder
wheels. Then press the DEL button. To confirm the delet-
ing procedure, all LEDs of the controller flash three time.
P. 26
NAVIGATOR EXPERT RDM
ENGLISH VERSION