Network Connection - Kandao Meeting Ultra Manual De Instrucciones

Remote Controller Pairing
�. Simultaneously long press the "OK" and "Volume -" buttons for about �
seconds until the indicator light blinks.
�. The indicator light is off after pairing successfully.
*Notes
After the first successful pairing, every time the user press any button on the
remote will automatically connect the device.

Network Connection

Wired network connection： Connect the network cable to the Ethernet port
of Kandao Meeting Ultra, and then configure the wired network information
in "System Initial Boot" or "Settings", such as DHCP, static IP, and network
proxy and so on.
Wireless network connection： Configure and connect the wireless network
in "System Initial Boot" or "Settings", including DHCP, static IP, network
proxy, etc.
Network Settings
Wi-Fi Disconnected
Ethernet Disconnected
Start
Press the remote control to return
EN