Tap Installation; Water Pressure Reducer; Keg Coupler Assembly; Keg Tapping And Untapping - LINDR SODA PYGMY Green Line new Instrucciones De Uso

13. TAP INSTALLATION

1. Turn the compensator lever (1.), so that it points down (see figure). The compensator lever on the
tap is used to adjust the flow rate.
2. Fit the tap perpendicularly onto the spline.
3. Secure with a flare nut and turn left. (loosen to the right).
4. Tighten with the enclosed wrench.

14. WATER PRESSURE REDUCER

The MRA 1 / 4-8 m regulator is recommended for the correct operation of the device.
( for SODA PYGMY 25 GREEN LINE it is part of the device )
1. regulator
2. speed fitting JG M 1/4 x 9,5 mm
3. manometr

15. KEG COUPLER ASSEMBLY

15.1 Outlet for Keg Pressurisation:
Variant of connection with the use of a bushing; the hose is fitted onto the bushing and affixed
with a clip.
WARNING: Before you screw the speed fitting onto the 5/8" thread, make sure the keg
coupler (air inlet for delivery medium) has a lip valve (check valve 15.A) fitted on it.
22
15.2 Outlet for Beverage:
Screw an F 5/8" x 3/8" (9,5 mm) speed fitting onto the keg coupler.

16. KEG TAPPING AND UNTAPPING

16.1 Keg Tapping
Procedure for tapping a keg using an S-system keg coupler.
16.2 Keg Untapping
Procedure for untapping a keg using an S-system keg coupler:
16.3 Keg Tapping
Procedure for tapping a keg using an A-system keg coupler:
16.4 Keg Untapping
Procedure for untapping a keg using an A-system keg coupler:
(see Fig. 13.)
(see Fig. 14.)
(see Fig. 15.)
WARNING: Make sure the adapter is clean before tapping the keg!
:
:
:
:
(see Fig. 16.)