Assembly; Mounting The Handle - Greencut Ggt650Xe Serie Manual De Instrucciones

66
Model/
Accessories
GGT650X-1 X
GGT650X-2
X
GGT650XE-2
GGT650X-3 X
GGT650X-4 X
GGT650X-5 X
GGT650X-6 X
GGT650X-7 X
GGT650X-8 X
GGT650X-9 X

ASSEMBLY

MOUNTING THE HANDLE

Position the handle at the desired height and secure it with the four bolts.
1
MOUNTING THE BARS
Steps to follow:
1. Release the clamping handle (2) until the accessory bar
snaps in gently.
2. Pull out the safety pin (1) and push the bar into the joint
until it reaches the maximum depth. Make sure the drive
rod fits properly into the power take-off shaft drive.
3. Turn the accessory bar until the safety pin snaps into the
accessory bar housing.
4. Tighten the lever (2) until you have checked that the
accessory bar is securely fastened.
X
X X
X X X
X X X
X X X
X X X
X X X
X X X
2
X
X X
X X X
X X X
X X X
3
2
X
X X
1