Checking For Leaks; Care And Cleaning - Glacier Bay Hd873X-4101 Guía De Instalación Y Cuidado

Installation (continued)
12

Checking for leaks

□
Turn the handle (F) to the full on mixed position.
□
When the valve body (D) is turned on, water
normally ows through the tub spout (J). To
activate the shower, turn the valve on and pull
the knob (1) up. Hold the knob (1) until the water
ows continuously from the shower arm (B).
Check for leaks.
□
Shut off the water at the faucet and supply lines.
J
13
Installing the shower head
□
Make sure the washer (1) is inside the
bracket (O). Hand tighten the bracket (O)
onto the shower arm (B).
□
Ensure the washer (2) is placed into each
end of the hose (P) for seal. Connect one
end of the hose (P) to the bracket (O) and
the other end to the shower head (C). All
connections should be hand tightened only.
□
Attach the shower head (C) to the bracket (O).

Care and Cleaning

□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
UP
FOR
SHOWER
1
B
F
J
1
O
C
2
P
14
D
B
2
P