LiftMaster 111014 Guia De Inicio Rapido

INTRODUCTION
The Power Line Converter allows the connection of a PNP sensor with an
active output to an LMi5 interface or other LiftMaster operators, which
expects dry contact signals.
The device provides +24VDC to the sensor from its onboard power
supply. The figure below shows the Power Line Converter's connection
diagram between LMi5 and WS-Sensor-E.
Carton Inventory: 1 Unit Power Line Converter device
Not Included: Mounting hardware, WS-Sensor-E, LMi5, 100MAPS
Input Power: 120 VAC 60Hz or 100MAPS (+24VDC)
Important:
Please refer to manufacturer's manual for
electrical specifications of the device.
114A5842
© 2023, LiftMaster
All Rights Reserved
Tous droits réservés
Todos los derechos reservados
CONNECTION DIAGRAM FOR
POWER LINE CONVERTER
WARNING: This product can expose you to chemicals
including lead, which are known to the State of California to
cause cancer or birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov.
PART #111014
Note:
Dry use only.
Secure firmly to the wall.
LiftMaster
300 Windsor Drive
Oak Brook, IL 60523
LiftMaster.com