Thermo TS403 Guia De Usos Y Cuidados

VACUUM INSULATED STAINLESS STEEL TUMBLER WITH STRAW
GENERAL CARE
- Before first use, wash all parts with warm, soapy water. Rinse all parts thoroughly and allow time to dry.
- Contents should not be left in the container for longer than 24 hours. As soon as possible after each and every
use, wash all parts with warm, soapy water. Rinse all parts thoroughly with clean water. Allow all parts to dry
completely prior to next use or storage.
- DO NOT use abrasive cleaners or scrubbers since they may dull the finish.
- DO NOT use bleach or cleaners containing chlorine on any parts of the product.
- This product is top-rack dishwasher safe; however, hand washing is recommended as the dishwasher uses
harsher detergents and hot water that may affect the appearance of your product.
- Residual contents may become trapped between parts, under gaskets (flexible band around lid and/or stopper),
or in straws. Although this products is top-rack dishwasher safe, hand washing is recommended to ensure that
these parts of the product are thoroughly cleaned.
- For maximum insulation efficiency, prechill the product just prior to use. Fill with cold tap water, attach lid, let
stand 5 to 10 minutes and empty water. After filling with contents, cover product with lid to increase thermal efficiency.
ASSEMBLY & USE
TUMBLER W/ STRAW
1. Remove lid (A/D) by twisting counterclockwise.
2. Remove straw (H) by pulling through bottom of lid (A/D).
3. Remove gasket (B/E) from underside of lid (A/D).
4. Wash all parts separately, then re-assemble. Ensure gasket (B/E) is
properly seated to minimize leaking.
5. Fill container (C/F) with contents. Do not overfill: Leave space for
lid (A/D) and straw (H), to avoid overflow.
6. Insert straw (H) through bottom of lid (A/D) so straw-notch (I) is at bottom.
7. Replace lid (A/D) by twisting clockwise.
CARE AND USE GUIDE
* Image for reference only: actual product may vary
D
A
B E
H H
C F
TS403 Tumbler w/ Straw TS405 Tumbler w/ Straw
H
I