EVBOX Dynamic Load Balancing Kit Manual De Instalación página 22

EN
10. If an RJ45 plug is not pre-installed,
install an RJ45 plug on the DLB
adapter end of the network cable.
11. Connect the network cable RJ45 plug
to the DLB adapter.
12. Remove the covers from the charging station.
Note
Refer to the installation manual of the charging station to learn about
the following:
Removing the covers from the charging station
◦
Finding the input connector for DLB
◦
Routing a network cable into the station
◦
18
4. Installation instructions