Merit Medical INTELLISYSTEM 25 Instrucciones De Uso

Inflation Device and Fluid
Dispensing Syringe
INSTRUCTIONS FOR USE
U.S. Patent Nos. 5,135,488 5,711,302.
Other U.S. and Foreign Patents Pending.
HANDLE
TRIGGER
DIISENGAGE
RED PRIMELOK CLIP
ENGAGE
PRIMELOK SLOT
DESCRIPTION:
The Merit IntelliSystem25 Inflation Device and Fluid Dispensing
Syringe is a 20ml disposable syringe with an integral pressure
transducer, threaded plunger assembly with lock/release bar, a
flexible high pressure extension tube, and a three-way medium
pressure stopcock. The IntelliSystem25 is designed to generate
and monitor pressures and dispense fluid with each turn of the
handle.
INSTRUCTIONS FOR USE:
This device is intended to be used only with the
IntelliSystem Monitor. Read IntelliSystem Monitor
Instructions For Use before use.
Before use, inspect the device and packaging to verify that no
damage has occurred as a result of shipping.
NOTE: To generate and monitor pressures over 20 ATM, 20
BAR or 300 PSI the IntelliSystem Monitor must have 6.0 version
software or greater.
CAUTION: Federal (U.S.A.) law restricts this device to use by or
on the order of a physician.
NOTE: The IntelliSystem25 syringe is packaged with a
perforated bag over the cable connectors. Leave the bag in
place until the syringe has been prepared with fluid. This will
prevent fluid contamination on the cable connectors.
WARNING: This device should not be used in the presence of
flammable anesthetics.
Manufacturer: Merit Medical Systems, Inc.
South Jordan, Utah 84095 U.S.A.1-801-253-1600
U.S.A. Customer Service 1-800-356-3748
Authorized Representative:
Merit Medical Ireland Ltd
Parkmore Business Park West, Galway, Ireland
400646002_004 ID 2022-01-10
PRIMING WITH PRIMELOK
TM
The PrimeLok allows purging of air
and excess fluid without squeezing
the lock/release mechanism. The
IntelliSystem25 is packaged with the
PrimeLok and with the lock/release
mechanism in the disengaged
position.
1. To engage PrimeLok, squeeze
handle and slide PrimeLok into
plunger.
2. To prep syringe, simply aspirate up
to 20ml of contrast solution or fluid
to be dispensed into the syringe by
pulling back on the plunger handle.
CAUTION: Inspect the syringe tubing
and stopcock (if used) to insure
ENGAGED PRIMELOK
that there is no air in the system.
3. Push handle against table to
remove air in syringe.
4. To disengage squeeze handle and
slide PrimeLok out of barrel. This will
allow the plunger to lock in position
and is now ready for use.
NOTE: The PrimeLok must be
disengaged before pressure can
be maintained by the lock/release
mechanism.
ENGAGE
PRIMELOK
DISENGAGE
PRIMELOK