Removing/Re-Installing The Oven Door - Dacor Dop48C96D Serie Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Oven Maintenance

Removing/Re-installing the Oven Door

Spread a blanket on a stable, flat surface where you can lay the door once you have removed it.
CAUTION
The 30" oven door weighs 42 lbs (19 kg). Grasp the door with both hands. Do not lift by the
handle.
Locked
Locked
92
English
FULL_DACOR_DOP48C96DLMDA_EN+MES+CFR.indb 92
FULL_DACOR_DOP48C96DLMDA_EN+MES+CFR.indb 92
1. Open the oven door fully.
2. In the bottom corners of the oven door,
Unlocked
Unlocked
3. Partially close the door to engage the
4. Grasp the sides of the door below the
5. Set the door down without damaging
6. Disconnect the cable's wire harness,
Step 6
7. When ready to re-install the door, stand
Step 8
8. Set the door down, and connect the wire
flip the hinge locks toward you to unlock
them. If the hinge locks are not fully
forward (see left), you cannot remove the
door.
hinge locks. (The door stops at this point.)
handle, and as you pull, gently jiggle the
door side to side as needed to loosen it.
the LED cable at the door's bottom right
corner.
and set the door (handle-down), on the
blanket you prepared.
at the top of the door, grasp each side
below the handles, and take the door to
the oven.
harness.
2023-02-23 오후 5:22:32
2023-02-23 오후 5:22:32
Tabla de contenido

Solución de problemas

loading

Tabla de contenido